Aluminum Display Case - Polish Product Review

[TheDukeOfIce]

Thanks. I will be heading out to get some 0000 Steel Wool and shine from homedepot then to start with to get it down to a manageable surface.

Patience and elbow grease will get them back to original form.

As a FYI - the Sheila Shine is a coating you leave on the metal, but it will drip over time down the sides. Keep a rag around the 4 I beam corners and you won’t ruin your floor

 

[AlanH]

Same.....Steel wool and Sheila shine did the trick.
However I started off with "Goof off". Really effective product.
Spray it on the affected area first and spread it on the metal surface and let set for some time.
Thereafter resume with steel wool and Sheila shine as recommended by OP.
Had restored 6 cabs using the technique.
Patience is key.

Is there a certain direction or should the wool be wet when I brush the metal. Dont want to ruin this cabinet in the process of bringing it back to life. Thanks for the help

 

[Fakir]

Is there a certain direction or should the wool be wet when I brush the metal. Dont want to ruin this cabinet in the process of bringing it back to life. Thanks for the help

Along the length is best. Avoid going width wise which is anyways about a couple of inches.
Hope this helps and good luck.