MongooseBlanco
I should Work at Oakley
I’ve found that I have to make both cuts on those OXM ones, even for the Juliet frame. If not, you have to use a lot of force to compress the orbital tab/flex couplers into the nose bridge while inserting the pins. A large nail clipper works well, obviously being careful not to trim too much off of the back.
Also, w/o trimming you could see the pointed ends of the couplers sticking out the nose bridge / orbital gap once reassembled.
Also, w/o trimming you could see the pointed ends of the couplers sticking out the nose bridge / orbital gap once reassembled.