My custom stuff (lens etching, 3d printing and vinyl)

[GRFMotorsports]

If you have enough, go two boxes wide. That’ll stop the sliding. But I can make you some of these too lol

This is what I was doing...

 

[SiRacer420]

This is what I was doing...

View attachment 639420

That’s perfect! That’s the same thing I was going for with mine with the taller stack at the back and slightly shorter on front.

 

[ShortChangeHero]

Hell yea. I love the rails. They conserve a lot of space and look sweet. They were a collab between myself and @SiRacer420

Thanks for look

Jesus Christ!!! That’s where all the minutes went. What kind of stands are on the sides.

 

[ZCForge]

Thats a very clean set up. I was thinking about using the old metal stand and have a long bar machined for the same effect. This would be a lot cheaper. Right now I use old boxes to line them up but they dont have the groove and slide around.

thanks, bud. I dig symmetry (can you tell?)

 

[ZCForge]

Jesus Christ!!! That’s where all the minutes went. What kind of stands are on the sides.

ya boy(@SiRacer420)'s 4 tier stands. I thought you knew my goal was an hour. I'm really close too

 

[ZCForge]

This is what I was doing...

View attachment 639420

ohhhhh let me get one of those blue topcoats. You surely don't need 3

 

[ZCForge]

This is what I was doing...

View attachment 639420

Get some rail and 4 tier stands and you’ll be set. I’m quite anal about the way my stuff is displayed. I have slight OCD lol

 

[GRFMotorsports]

ohhhhh let me get one of those blue topcoats. You surely don't need 3

Im down to 2 now... someone pried one out of my stiff cold fingers.

 

[ZCForge]

Im down to 2 now... someone pried one out of my stiff cold fingers.

2 is still 2many!

 

[ShortChangeHero]

ya boy(@SiRacer420)'s 4 tier stands. I thought you knew my goal was an hour. I'm really close too

Damn! They look good, wish I had a bigger case to use those.